Log in

View Full Version : V5+ upgrade to V6


iq180
09-15-2014, 02:04 PM
I have just upgraded my V5+ to V6 and it works perfect.
I used the V6 allchunk file with the loader and now the V5+ ID as a V6 in the receiver menu so the V6 allchunk file posted should load on any V model jynxbox and can be used to repair any clone jynxbox that's is dead from a clone
kill code, you will need to use the loader and loader cable.
iq180
09-18-2014, 12:20 AM
Well I was having some problems with the v5+ overheating after the upgrade but I found that the crap fan that came with the v5+
was stuck once more, I took the fan out and cut the wires off to use on another fan, I cut a 1&1/2 round hole in the top cover over the JB200 and bolted a fan from an old xbox 360 intercooler to the top of the box & no more heat problems.
freereign
09-18-2014, 07:24 PM
ok so will this work for V7????
iq180
09-18-2014, 08:35 PM
ok so will this work for V7????
Yes it should work just fine.
Mudo
09-19-2014, 02:56 PM
I have a V5 + is giving me problems and I would like to know how to make that change to my v5 +. Problem is that it gives me a lot of the wifi off when I'm watching tv. Thanks for the help you can give me.
iq180
09-19-2014, 03:16 PM
I have a V5 + is giving me problems and I would like to know how to make that change to my v5 +. Problem is that it gives me a lot of the wifi off when I'm watching tv. Thanks for the help you can give me.
That sounds more like an overheating problem than a firmware problem, when it drops the wifi put your finger on the coax cable
at the back of the box to if its hot, if it is you have fan problems.
TurboPirate
09-19-2014, 10:19 PM
ok so will this work for V7????

Test the 2.51 firmware the V7 has first then try the V6 file if the 2.51 gives you pproblems..
Mudo
09-21-2014, 01:59 PM
I have just upgraded my V5+ to V6 and it works perfect.
I used the V6 allchunk file with the loader and now the V5+ ID as a V6 in the receiver menu so the V6 allchunk file posted should load on any V model jynxbox and can be used to repair any clone jynxbox that's is dead from a clone
kill code, you will need to use the loader and loader cable.

I would like to upgrade my v5 + Might explain how to do it I have no experience doing this.
TurboPirate
09-21-2014, 03:43 PM
I would like to upgrade my v5 + Might explain how to do it I have no experience doing this.

Using the loader and serial cable. TurboPirate