what switch

[scooby8888]

hey guys sorry to ask but trying to clean up my sat mess up a bit.
I've got the following setup and I was wondering if I could use one powered switch to run everything I can change out lnbs if its easier that's not a problem just looking for the easiest solution
I've got
2 standard lnbs running 110 and 129
1 linear running 118/119
2 legacy duals running 82 and 91
I have it all working with 4x4 and diseq and sw21's but its a mess any advice
thanks

[Terryl]

Get rid of the legacy's and replace them with the standard type you have for 110 and 129, then if you only need to run one receiver then get a Diseqc 2.0 8x1 switch, that way it does not need to be powered, as the switch will select the single LNB it is told to by the receiver, if you need to run more then one receiver they (EMP) make an 8x2 switch.

Any more then 2 receivers then you will need an externaly powered switch.

[scooby8888]

ya I forgot to mention I have 4 boxes, sonicview hd, pinwheel, jynxbox and a nano premium
thanks