Help with dish settings pinwheel hd mini and dish pro plus Lnb.

[dssrocks]

I am getting signal on both 119 and 110 but it is very slow and I'm getting double channels on a scan, I think I have setting issue.

119:
Lnb type: dish pro
Local frequency: 11250
22khz: off
Tp frequency: 12239/h/21500
Diseqc parameter: a
Diseqc 1.1: 1
Legacy switch: none

110
Lnb type: dish pro
Local frequency: 11250
22khz: auto
Tp frequency: 12224/v/21500
Diseqc parameter: none
Diseqc 1.1: none
Legacy switch: none

[whoknows]

You have disq parameter to none on 110. When you are in antenna settings start with disq parameter "a" on 119 and wait for it to say locked to at the top of page. If it doesn't then right arrow the "a" and it will change to "b". Do that for 110 also, waiting for a moment to see if it "locks to" Then once you have both satellites switching properly(locked on satellite) you won't get duplicates.(same satellite)

21500 are HD transponders. Scanning should start with SD transponders which are 20000.

[dssrocks]

Thank you for the reply. I'm still having problems with my configuration. I can't seem to get a signal on sat 110 by changing my diseqc parameter to anything other than none. Does the dish pro plus nob use 22khz? Should I have 22khz on or off?

[Terryl]

I don't know if your settings are correct or not as I don't have one of those receivers, but if you were to look into (or someone can give us the right settings) the ones I have highlighted,(and my suggested changes) you may get some better results.

119:
Lnb type: dish pro
Local frequency: 11250
22khz: off
Tp frequency: 12239/h/21500>>>>>>>>>>>> use TP12297L (H), as TP12239L (H) is a spot beam.
Diseqc parameter: a>>>>>>>>>>>>>>>>>>> What other settings do you have for this?? As the Dish Pro LNB only works on Diseqc 1.0, and should be set to Diseqc port #1
Diseqc 1.1: 1>>>>>>>>>>>>>>>>>>>>>>>> Should be set to "NONE"
Legacy switch: none

110
Lnb type: dish pro
Local frequency: 11250
22khz: auto >>>>>>>>>>>>>>>>>>>>>>>Should be set to "OFF"
Tp frequency: 12224/v/21500
Diseqc parameter: none >>>>>>>>>>>>>>>Should be set to Diseqc 1.0 port #2
Diseqc 1.1: none
Legacy switch: none


And what type of Dish Pro LNB??? A DP Twin?? (one large oval eye)
Or two DP single LNB's and an external switch?

[dssrocks]

Thanks again, I will try the settings again. My Lnb is the large oval one with the switch built in. It is called a dish pro plus with 3 ports. 1&2 are below the 110 Lnb and Lnb in port is below 119.