ilink 9800dh SE

[vic24551]

hi, After a few little problems upgrading the ilink 9800hd se receiver, I installed the 2 latest files & the same no signal
issues continue, the files are: v333, v338.

[steven charles]

friend try posting the settings for each sat your pointing too,and if your using a switch post what kind your using....

[ICEMAN]

Yes your problem could be in your anntena settings..
Like SC suggested post your settings so we can help you better..and what type of lnb you are using..

[vic24551]

Yes your problem could be in your anntena settings..
Like SC suggested post your settings so we can help you better..and what type of lnb you are using..
hi & thank-you! I am using a 4x1 diseqc switch with legacy lnb, I have used this setting for all my fta receivers
no problems at all, all channels come in fine, when I turn the unit off and next day turn it back on! no signal
sign is all I get, then I press menu and go to the satellite menu were no signals show for diseqc 1,2,or 3.

[steven charles]

hi & thank-you! I am using a 4x1 diseqc switch with legacy lnb, I have used this setting for all my fta receivers
no problems at all, all channels come in fine, when I turn the unit off and next day turn it back on! no signal
sign is all I get, then I press menu and go to the satellite menu were no signals show for diseqc 1,2,or 3.friend I think I know what your talking about,i had the same problem with the legacy lnbs,sometimes in the evening and mornings, it would show some channels with no signal at all,not sure how I fix it,but try doing a factory default on your receiver and then re-enter the settings for each sat and scan for channels or try re-aiming the dish,can,t remember how I fix mine but its one of this steps,good luck friend....