Now testing, jynxbox V10

[iq180]

Now testing the new jynxbox V10 and I am not happy.
The power supply cord is bad and will need to be replaced, the outer cover is pulled off the inner wires.
The fan is glued to the top of the capacitors over the CPU cooling plate, that's just plan stupid.
On a good note it does have an SD card slot & 2 tuner card slots.

[iq180]

The 3.3.10 allchunk dump file for the V10 is now in the all other receiver file section.

[iq180]

I had to stop the testing on the V10 to prevent damage to the JB200 module, its getting to hot.
Now to see if I can get the glue off the fan without damaging the capacitors.

[crazy carl]

Keep us posted good sir this did sound promising until now

[Nostradamus]

2 tuner slots are not of much use if it is overheating with just one tuner installed

[iq180]

2 tuner slots are not of much use if it is overheating with just one tuner installed
That was with 2 tuners, 1 JB200 & 1 DVBS2 tuner.

[iq180]

Ok I have fixed the heat problem, I used the same fan that came with the V10, I used the magnet trick and put the fan on the inside
top case, its working great now.

[ddowder]

Do you still load all chunks via serial? Is pic Q any different then other models? For the $ looks like decent unit.

[iq180]

Do you still load all chunks via serial? Is pic Q any different then other models? For the $ looks like decent unit.
Don't buy it yet, it has still got some problems, I have not been able to get the DVBS2 tuner to work.

[crazy carl]

File related?

[iq180]

I now have the DVB-s2 tuner up and running, the recording and playback are working perfect, no freezing.:yeaah:

[crazy carl]

I now have the DVB-s2 tuner up and running, the recording and playback are working perfect, no freezing.:yeaah:
Anything after market to get er going?

[iq180]

Anything after market to get er going?
Moving the fan seems to have fixed all the problems, I think the tuners were just overheating.
As soon as I have time I think I am going to put two 3 inch 5.5 volt fans in it and run them on the OE 12 volt plug, yes I did say
use a 5.5 volt on 12 volts, you can do that if you know how, I will post a how too if I do it.

[iq180]

Here is how to wire up 2/ 5.5 volt fans to run on the jynxbox 12 volt OE fan plug.
Take 1 black wire from one fan and solder it to the red wire of the other fan.
Now the other red and black wires on the fans will solder to the red and black wires that you cut off of the jynxbox OE fan.

[iq180]

The V10 jynxbox is a very strange receiver, like all receivers it don't like heat, but this receiver don't like cold as well, if its too cold
you need to let it warm for 10 min then do a hard boot before you can use the remote.