DiSEqC SW 1.0 & 1.1

[dtvbandit]

On the Antenna menu I noticed that there are DiSEqC SW 1.0 & 1.1.

What are the differences and which one should I be using?

Thanks

[Hunter11]

The SW 1.0 is for a single Diseqc.
C/p from Crazed
DiSEqC 1.0 is for switches with up to 4 ports.
DiSEqC 1.1 is for switches greater then 4 ports.
DiSEqC 1.2 is for motorized setups.

22hz On/Off is for LNBs with internal switches

On the Antenna menu I noticed that there are DiSEqC SW 1.0 & 1.1.

What are the differences and which one should I be using?

Thanks

[squirtNcider]

So if you were to use a diseq and a 22khz switch, (3 ports for sats and the 22 kHz plugged into the 4th diseq port with 2 more sats used) would you have to make it 1.1 in the receiver menu instead of 1.0. Just wondering as I had probs using the diseq with a 22 kHz switch.
Hope this isn't considered a hijack as it does explain the 1.0 vs 1.1 on the diseq.
Sorry if it is.

[Hunter11]

Here is a link for more info, I know if you use a sw21 that you use the 1.0 and select the SW type to match for the set up you are describing to access a port on the diseque to add the 5th sat.

This is with the sw21.
82 sw21-1----port1
91 sw21-2----port1
110 port2
119 port3
129 port4
22khz off on all


22khz switch in place as follows.
82 port1
91 22khz switch On side Tone ON
110 port2
119 port3
129 port4
Out (to receiver) port to 22khz Off side.


http://www.saveandreplay.com/Install_switches.asp


So if you were to use a diseq and a 22khz switch, (3 ports for sats and the 22 kHz plugged into the 4th diseq port with 2 more sats used) would you have to make it 1.1 in the receiver menu instead of 1.0. Just wondering as I had probs using the diseq with a 22 kHz switch.
Hope this isn't considered a hijack as it does explain the 1.0 vs 1.1 on the diseq.
Sorry if it is.