Dreamlink HD bad or no signal

[gera815]

I just installed a dish 1000.2 no switch or power inserter. I have a dreamlink HD and a regular dreamlink SD hooked up to the satellite. Both receivers on at the same time. SD receiver works excellent. HD receiver keeps giving me Bad Or No Signal a lot. I restart it and then it gets fixed but then it comes back. Can someone tell me the problem

[steven charles]

I just installed a dish 1000.2 no switch or power inserter. I have a dreamlink HD and a regular dreamlink SD hooked up to the satellite. Both receivers on at the same time. SD receiver works excellent. HD receiver keeps giving me Bad Or No Signal a lot. I restart it and then it gets fixed but then it comes back. Can someone tell me the problemfriend you need a dp44 and power inserter for more then one receiver,hope your hd module its not going bad,once they start to over heat to much its a matter of time....

[Costactc]

Try hooking up the hd receiver by itself and see if it still persists. If so, go into manual scan and switch through tp till red lines become green- this has worked for me numerous times. If all good, get the proper switch as SC mentioned in the previous post.

[lilred]

I use the same dish gera815 and it is a power hog! You need to use a power inserter on port 1 and your stb's on port 2 and 3 or use dp44