Multi satellite setup causing rebooting and wiping channels

[dcapper]

Has anyone come across this? I am running Dish 119 port 1 diseqc, 110 port 2 diseqc, 129 port 3 diseqc, and Bev 91 port 4 diseqc through SW44, 82 port 4 diseqc through SW44. The receiver reboots constantly and then it will wipe all the channels. I tried to delete a pile of channels and any duplicates and it didn't work. I replaced the 8psk module and replaced the EMP Centauri diseqc with another one. Any ideas? Do I need an inline amp of some sort? Or is there another way to hook up my setup that will work better?

[Anubis]

Have you tried factory defaulting the unit and starting from scratch again?

[dcapper]

Have you tried factory defaulting the unit and starting from scratch again?

I factory defaulted then loaded the cleaner via serial then factory file then newest file. It's something to do with the sw44 conflicting with the diqesc I think. If I don't hook up the sw44 it seems to work fine. I posted in the lnb section which I probably should have before. I explained it better there. But maybe you have some ideas?

[fn59]

Why the sw44? Is there subbed receivers also using the sw44? Also do you have a power inserter on port 1 of the sw44.
I've seen plenty of setups with the satellites you want. Usually the have bell 91 and 82 going to a sw21, which is then connected to port 4 of the diseqc.

[dcapper]

Why the sw44? Is there subbed receivers also using the sw44? Also do you have a power inserter on port 1 of the sw44.
I've seen plenty of setups with the satellites you want. Usually the have bell 91 and 82 going to a sw21, which is then connected to port 4 of the diseqc.

Yes one sd Bell and one dual tuner Bell. I needed 4 outputs so that's why I installed the SW44.

[fn59]

Have you tried hooking up directly to the sw44 to see if you can scan both 91/82 ?