Have Dishpro Twin Lnb, Need Help!

[gwrowe]

My friend has a bell dish with dishpro twin lnb, built in sw21, and is trying to get proper settings to get it to work with a JB V6, can't seem to get it working right, need help, plus he has ordered a dish 1000.1 or 2 dish, the settings for that he will also need, to connect his JB V6 to it! Can anyone help Please!

[Terryl]

Well the proper setting for the LNB type would be OCS-DP. (or Dish)

LNB frequency would be 11250.

Diseqc switch settings would be, Diseqc port #1 = 91W (or 119W), Diseqc port #2 = 82W (or 110W)

The same frequency for the Dish 1000.1 LNB, Diseqc port #1 = 72.7W, Diseqc port #2 = 61.5W, Diseqc port #3 = 77W

The switching for the Dish 1000.2 LNB, Diseqc port #1 = 119W, Diseqc port #2 = 110W, Diseqc port #3 = 129W

Diseqc port # 4 is open for any single DP type LNB, but will not work with the DP twin LNB.

[gwrowe]

So the JB V6 will work with twin LnB for 110/119, the 1000.2 is the replacement dish, when it gets delivered.

[Terryl]

It should work fine if the settings are correct.

The Jinxbox will have power problems with the Dish 1000 LNB, so he will need a DPP 44 power inserter, (switch is not needed, only the power inserter) it has to be run on it's own coax directly up to the #1 port on the LNB, the other 2 ports on the LNB will run the receiver(s) just fine after that is done.

The Dish 1000 LNB needs 750 mA of DC current to run right, a bit more if a second LNB is tied into it's LNB input port.

[Anubis]

Moved this out of the files section.

[gwrowe]

OK the dish 1000.2 has been delivered, it is pointed, getting 99% quality on 119 on centre lnb, power inserter is connected to port1, the downstairs cativeworks receiver is connected to port 2 and working perfectly, without setting lnb to OCS-DP, the JB v6 is connected to the power inserter, and no matter what settings I try, iget know 110/119, but I get signal and Quality on 129, the port setting is port 3 in the stb, I also found out he has a 3rd stb in the livingroom, don't know whether that works at this time, what we need to know about is the settings for the JB V6. Need help thank's in advance!