serna561
06-15-2015, 01:41 PM
I just bought a Jynxbox Ultra HD V7 with Firmware 2.57. I have a dish 500 with legacy LNBs and I’m using a diseq switch. I am not able to scan all transponders or all the channels. I also can’t lock on to any transponders that has a good signal or quality. I am using satellite 119 and 110 and my settings for 119 are:
Tuner- LNB fixed
LNB Freq- 11250
Diseq 1.0- port 1
Dseq 1.1- disable
Legacy SW- off
Legacy LNB- OCS-DP
22k- off
Polarity- auto
The settings for 110 are the same except for the Diseq 1.0 is set to port 2. When I try to add the correct transponders to each satellite it doesn’t find any channels and the signal is at 45%. I have checked my dish with a meter and it scans close to 90%. Any help or feedback would be appreciated.
Tuner- LNB fixed
LNB Freq- 11250
Diseq 1.0- port 1
Dseq 1.1- disable
Legacy SW- off
Legacy LNB- OCS-DP
22k- off
Polarity- auto
The settings for 110 are the same except for the Diseq 1.0 is set to port 2. When I try to add the correct transponders to each satellite it doesn’t find any channels and the signal is at 45%. I have checked my dish with a meter and it scans close to 90%. Any help or feedback would be appreciated.