no signal

[bachan]

my box was working fine. I tried to reboot and I am getting 42 % of signal strength. and than I get display no signal including 1oo and101 channels too. I don't know what happened please help
thanks

[gAsH]

Bypass the switch first to make sure that is not the problem but if you have luck anything like mine the JB200 module died.. You can order a new one on ebay for $25 or so .. but just hope its a dead switch.

[DJMark]

I had a problem that my box would get really hot and then it would lose signal. If your box is getting really warm, try adding a fan. There are some great videos on youtube that show you how.

[Newfygarge]

some good info here too in clone section for jynxbox

[bachan]

how to by pass the switch. thanks

[gAsH]

how to by pass the switch. thanks

Connect the LNB directly to the box. no switch in between. If still no signal then you probably need to replace the JB200 which is a simple procedure. GL

[bachan]

I just replaced 2000jb and every thing is normal......gash.....you all..... thank you for your help.

[Dan2015]

i have a jynx v3 when iam watching a lot of differnt channels it will work fine for a 20 mins and then it will lose singal is anybody eles haveing this promblem thanks

[tubbs]

YES,
I am having the same troubles with a V6

works fine with god signal, 10 minutes later signal is at 42%, 15 minuets later signal dies again!

[The Noof]

YES,
I am having the same troubles with a V6

works fine with god signal, 10 minutes later signal is at 42%, 15 minuets later signal dies again!

Try a laptop cooler & see if it helps.Probably too late though if it was a heat related issue:the Jb modules are REALLY fragile .