Kohli
08-09-2015, 07:35 PM
Tried to recover loss of signals on sats.- 110w, 118w, 119w, 129w , it happened when sat 110w channels were lost recently and i tried to change the LNB and readjust the dish, didn't recover 110w channels but lost all the signals (95%strong) on LINKBOX 8000HD PLUS. Factory default didn't work Then installed the jumper between BC34(BOTTOM SIDE LEG) AND BC37 RIGHT LEG (alternative to M1). Even this jumper fix as per:
Sticky Thread Sticky No Signal / Quality Level for Linkbox 8000HD (July 2, 2013)Repair picture:::
Started by CHEVY85, 07-18-2013 12:01 PM
The above jumper didn't work TO RECOVER THE SIGNALS, What could be the problem and how to get the signals back on this receiver. all programs, menus etc. are working except the signal is not there to rescan all the channels which were lost due to factory default. And the voltage at BC34 IS 12-14V without the jumper fix and no volts after the jumper is installed. Please help.
Sticky Thread Sticky No Signal / Quality Level for Linkbox 8000HD (July 2, 2013)Repair picture:::
Started by CHEVY85, 07-18-2013 12:01 PM
The above jumper didn't work TO RECOVER THE SIGNALS, What could be the problem and how to get the signals back on this receiver. all programs, menus etc. are working except the signal is not there to rescan all the channels which were lost due to factory default. And the voltage at BC34 IS 12-14V without the jumper fix and no volts after the jumper is installed. Please help.