How to fix missing tps to scan and get working channels

[keylow]

so this took a while to figure out to get it working hopefully you can too by follow these steps
Remember you must scan all the the tps you changed use the list that is down there make sure you scan all of them after you add the info

1. Delete all channels
2. auto scan
3. using a pc on the same network goto hxxp://192.168.*.*:9981 please change the stars to the end of you internal ip
4. when the page opens click on configuration --> DVB Inputs
5. click on select tv adaper --> click amlogic dvb frontend
6. click multiplexs --> click add mux(es) manually
7. in the pop up window you will see
OK PEOPLE THIS IS GOING TO LOOK WEIRD BUT IT WORKS PLEASE FOLLOW!!

Frequency (kHz) : 1241400
Symbolrate (baud) : 2150000
Fec : 2/3
delivery system : sys_dvbs2
constallation : PSK_8
Polarisation : H
Sat config : 119W

8. Now we will do the same thing for the these tps
(I recommended to do one sat at a time if not you may have to repeat work)

119
12414 H
12428 V
12486 V

110
12355 H
12443 H
12516 V

129
12526 V

9. Now we go back to the dreamlink t6 and go to the sat part
10. pick the sat you are doing
11. change the scan mode from auto to manual
12. pick the tp you have changed yes it will still say 20000
13. change the symbol rate to 21500
14. change the modulation to 8PSK
15. search sat
16.do not auto scan or you will have to start again

[xtreme1]

Why not just manually enter the missing TPS??? It works for me,very simple,no need to erase channels.

[nobodyspecial]

Why not just manually enter the missing TPS??? It works for me,very simple,no need to erase channels.

people were entering the info scanning and not getting the channels

[ddowder]

I can never get manual scan to save the channels.

This is very helpful thank you!



Why not just manually enter the missing TPS??? It works for me,very simple,no need to erase channels.

[xtreme1]

Suit yourself boys....eg. I scanned bird 91.1 and came back blank on the channel that plays TWD.
-seach mode to Manual scan
-make antenna setup is correct
-manual find the missing channels,enter the correct frequency,symbol rate,polarity and modulation for the transponder to the specific channel. in my case it was 12268 L, TP4.Done, it works.... or add channels to your favorite list
-back to channel manger
-To group management and add to your favorite list

[Benney]

Well we now have to ways to try fix this little issue.

Thanks guys.

[xtreme1]

You are right Benney, more info is way better then no info... good topic Keylow