jb200 or diseq

[falukalu]

folks I need some advise on this issue
I have 110 119 118.7 129 91 and 82 satellites. It was working till last night.
I am now only getting signal on 118.7 and 91..

I have tried a new diseq switch but did not help. I tried a spare JB200 (Not sure if spare tuner is 100% good). I still got signal only on 118.7 and 91.. I am leaning towards following.

1) I need a new jb200 tuner because non mpeg4 signal works (118.7 and 91)
2) My receiver is fried since I tried a spare tuner and did not help.
3) My LNB is fried or short.

I can eliminate option 3 because the single low frequenciy LNB works on 118.7 but not 119

Any help or advise is appreciated. Thanks

[gwrowe]

You will have to connect each individual lnbs to receiver to troubleshoot your problem! This will tell you if you have a bad cable/ Lnb/ or JB200. Use a female barrel connector to do this! If you get signal on all sats then module is fine! If you don't get signal on a couple of them check cable first then Lnb!