need your help sat 119 no signal

[shedevil]

hope you can help
I have no signal on sat 119 only; the signal strenght is 42, I changed the jb200 on my jynxbox but still the same
result, all other sat 110 and 129 are working fine

could it be the LNB on my roof thats fried? or could it be the disecq switch for which I dont kmow what is a disecq switch


thank you in advance

[Terryl]

`We need more info on your setup, how many LNB's and type, and any external Diseqc switch.

If you have a Dish 1000 LNB and are using it without a power inserter you could have damaged the receiver.

[shedevil]

thanks Terryl for replying so quickly. I am
clueless on what type of LNB I have , I know I have one dish with 4 LNBs

thats about as much as I know

all other sats work fine except for 119 signal is at 42, usually when this happens I just change the jb200 and it works fine after but this time it didnt work.

[dishuser]

thanks Terryl for replying so quickly. I am
clueless on what type of LNB I have , I know I have one dish with 4 LNBs

thats about as much as I know

all other sats work fine except for 119 signal is at 42, usually when this happens I just change the jb200 and it works fine after but this time it didnt work.
did you try a different TP?

[Terryl]

Can you take a photo of it an post it here?And as Dishuser mentioned, try a different TP like 12414.

[shedevil]

yes I tried a different tp and the signal strenght and quality is always 42

I will take a picture and post it

thank you both for your help

[The Noof]

yes I tried a different tp and the signal strenght and quality is always 42

I will take a picture and post it

thank you both for your help

If all the lnb's are of the same type, transpose the 119 with the one used for 110 to confirm/eliminate it as the issue.

[Mavrick]

#1 - Swap the 110 & 119 cables around up at the LNB's, if the issue jumps to the other sat then you know it's something in the cables or switch and not the LNB.

#2 - If swapping the cables doesn't change anything, bypass the switch with a barrel-connector so only the 119 LNB is connected and runs direct to the receiver, if still no change then it's a good chance the 119 LNB is shot or it got moved slightly.

NOTE !!! Remember to shut off your receivers main-power before disconnecting ANYTHING in your system.

[Terryl]

We need to know the brand/type/manufacture of the LNB(s) before swapping out stuff.

[shedevil]

thanks everybody for your help, it was the Lnb, I bought a new one and installed it and everything works now

agsin thank you all , greatly appreciated