View Full Version : rebooting
booter
03-31-2018, 04:24 PM
Having same problem with 2 receivers
Maybe something came down the pipe for dreamlink
nobodyspecial
03-31-2018, 04:36 PM
Having same problem with 2 receivers
Maybe something came down the pipe for dreamlink
no it didnt
booter
03-31-2018, 05:29 PM
Any ideas then for this coincidence?
Thanks
nobodyspecial
03-31-2018, 06:49 PM
Any ideas then for this coincidence?
Thanks
check for a short in your setup thats common to both receivers
booter
03-31-2018, 06:52 PM
2 different setups!
nobodyspecial
03-31-2018, 06:58 PM
2 different setups!
then post more info
booter
03-31-2018, 07:07 PM
I found that when I disconnect the Ethernet cable it boots. It will go into the reboots when Ethernet cable is connected.
Strange!
That same Ethernet cable works OK with a iptv receiver I have, so it cannot be that.
nobodyspecial
03-31-2018, 07:15 PM
I found that when I disconnect the Ethernet cable it boots. It will go into the reboots when Ethernet cable is connected.
Strange!
That same Ethernet cable works OK with a iptv receiver I have, so it cannot be that.
no it could still be the ethernet cable I would try another one first before ruling it out
booter
03-31-2018, 07:56 PM
Tried another Cable ....still same problem.
Bummer
nobodyspecial
03-31-2018, 10:04 PM
have you powered off and disconnected all cabled and powered on?
booter
03-31-2018, 10:50 PM
Yes. ...Usually a I can figure these problems out through process out through process of elimination.
Not this one.
timc2
03-31-2018, 11:36 PM
Yes. ...Usually a I can figure these problems out through process out through process of elimination.
Not this one.You may have messed up the network part of the board if you were just taking the plug in and out with the receivers on.If use the same cable between iks and iptv. The only other thing you can try if you haven't yet is make sure it's plugged in and restart your whole network.
rat123
04-01-2018, 01:48 PM
Hi
unplug network cable
receiver will boot up
goto where your setup servers
turn south off
and plug in network cable
turn receiver off and then back on and receiver should stay on
i have north also and all is working. There must be a problem with the south server
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.