Bev?

[khyiat88]

Using the latest bin file,after the scanned i cannot get cp24 and most of the channels doesn't?Planning to subscribe again so i need some info before i buy a new code.Thanks in advance.

[Actv8]

Rescan again

[nobodyspecial]

Using the latest bin file,after the scanned i cannot get cp24 and most of the channels doesn't?Planning to subscribe again so i need some info before i buy a new code.Thanks in advance.

post your lnb type,switches etc and your settings for both sats

[khyiat88]

lnb-on frequency range:900 -2400mhz
lnb type-on
lnb-frequency-11250 etc,etc
lnb-22khz-off
diseq sw-1 for sat 82
2 for sat 92
legacy-off
signal-86%
quality-87%

Already rescaned a few time,still not getting cp24 and tsn 2,4,5 and others.This started last month when so many ch were down,thats when i rescaned ,this never happened before no matter how many time i scan.Even tried manual and pid scaned too but nothing help.Thanks.

[nobodyspecial]

does the correct sat appear at top?
Also what receiver do you have because those are not dreamlink settings?

[khyiat88]

Yes they do show the sat on the top right corner,i am using the dreamlink t5 rec.What is the right set up then?Thanks.

[dishuser]

what type of lnb(s) are you using?

[fn59]

What type of lnb is on the dish?
If a pro installed the dish, the usually have 91 on sw21 port 1 , 82 on port 2.

[dishuser]

What type of lnb is on the dish?
If a pro installed the dish, the usually have 91 on sw21 port 1 , 82 on port 2.

no they don't

[khyiat88]

using dual digiwave lnb and i am using diseqc 4/1 switch.Have no problem for over 6 years,never any ch missing.So for what my set up should be for the dream link t5 rec?Any help is highly appreciated as i am planning to subscribe from here.Thanks.

[dishuser]

using dual digiwave lnb and i am using diseqc 4/1 switch.Have no problem for over 6 years,never any ch missing.So for what my set up should be for the dream link t5 rec?Any help is highly appreciated as i am planning to subscribe from here.Thanks.

legacy should be on

[nobodyspecial]

using dual digiwave lnb and i am using diseqc 4/1 switch.Have no problem for over 6 years,never any ch missing.So for what my set up should be for the dream link t5 rec?Any help is highly appreciated as i am planning to subscribe from here.Thanks.

your port settings will depend on where you have them on your switch
Its possible your switch is toast You can bypass the switch and check each sat by running directly to receiver
you will need to power off dreamlink in back when doing this
Also turn off diseq

[jets]

CP24 SD is on sat 91, TP 12355, 20000, H, DVB. CP24 HD is on sat 82, TP 12618, 21500, H, Turbo. Do a manual scan of those two TP's and you should be good to go. If you don't have the TP's in the list add them.