How setup 9241 to t5

[tripeux]

27312by27312

how I can plug my coax from outside to my t5 if I have this splitter at 9241? I always scan for 82-91 and I can't have 91...I scan 91 and he found channel from 82...

I try different setup from diseqc and lnb I can't scan 91

does it exist another way to take my two input in 9241 to put together?

thanks for your help

[dishuser]

that isn't a splitter
it's a diplexor for running dual

[Terryl]

That is a DP Plus separator, it is only used on Dish or Bell OEM equipment, you can't use it on FTA receivers it will not work, they do not have the correct software to run it.

[dishuser]

That is a DP Plus separator, it is only used on Dish or Bell OEM equipment, you can't use it on FTA receivers it will not work, they do not have the correct software to run it.

it will work with a sonicview elite

[tripeux]

it will work with a sonicview elite

thanks for your reply, my only way is install new setup with dual lnb direct to FTA with one diseqc....

[fn59]

since you're oem receivers using a dpp separator, you have a dpp lnb, either twin or quad. So just run another cable for dreamlink.