nfusion and dp34

[bubbs16]

im trying to set up nf hd with 1000.2 and am running into tons of issue.s finally took out dp34 switch as i thought you had to use that it shows it in the manual of it. I can get 119 and 129 just fine but ONLY HORIZONTAL TP's . It isnt getting the verticals. I also cant seem to find 110. could be some branches in the way . how do i get the verticals to come in ?

[dishuser]

im trying to set up nf hd with 1000.2 and am running into tons of issue.s finally took out dp34 switch as i thought you had to use that it shows it in the manual of it. I can get 119 and 129 just fine but ONLY HORIZONTAL TP's . It isnt getting the verticals. I also cant seem to find 110. could be some branches in the way . how do i get the verticals to come in ?

what are your settings?

[bubbs16]

Well after I put that I went out and tight end every thing down and came inside and had verticals on 119. It will say 119 to on top right. Showing that's what im pointed at. So now 119 is solid h and v. 129 h still Com in for most part but I noticed some would go out then come. Back. And when I put 129 on v tp it show 129 w EchoStar then switches and says 119 lol. Very odd.
Settings are for now
Standard lnb 1125....
Diseq1. 0 (dp34)
Pt 1 for 119
Next one woukd be port 2 for 110
Next port 3 for 129

Should I have 22khz switch on in I nb type?

I've never used a 1000. 2 dish before. No in not using a switch as I read 1000.2 has one inside it. I wonder if it is drawing more power. The Nfisiin can handle? Cause of the stacking of. The tps inside the lnb switch?

[dishuser]

you don't have a standard lnb though

[bubbs16]

Well I had it set to dplnbnf but it doesn't get as u kid as signal and quality and doesn't seem to work very good. What you suggest it be? What's going on?

[Mavrick]

The nfhd puts out 1000mA and should power that LNB as long as it's working properly. The LNB setting should be DPLNBF and you should be connected to port #1 on the LNB. If you are using the "in" port on the LNB for anything then you will need extra power to run that setup, also if you have a long cable-run that might also cause issues. If I remember correct you have to re-boot the receiver when you make any changes in the settings, your Diseq should be......
Port 1 - 119
Port 2 - 110
Port 3 - 129

You should NOT have 22khz switch on .

[bubbs16]

i had all the right settings , tried everything. What it ended up being is it doesnt have enough power. I added a additional dtv receiver hd model just to help power it and everything works flawless on h and v tps now.