View Full Version : Dreamlink t 5 connection
beefcake
10-22-2018, 09:24 PM
HI i was out voteing today and when i came back the power was off , now i'm up and running but my t5 says not connected to the internet . I changed ethernet cables from my android box to my t5 and still no connection but my android box is working . Did the suddent loss of power affect my t5 , does a suggestion thanks .
Dodgem
10-22-2018, 09:30 PM
Restart your router.That should pick up the ip address again.
beefcake
10-22-2018, 11:22 PM
Thanks DODGEM don't that 3 times modem & router and still no internet connection , i been now 3 hours tearing everything apart and confussed thanks
Dodgem
10-22-2018, 11:29 PM
Thanks DODGEM don't that 3 times modem & router and still no internet connection , i been now 3 hours tearing everything apart and confussed thanksHave you gone into settings to see if you are getting a ip address?I know i have seen it happen at my Niebuhr's and usually leaving the receiver on and restarting the router gets it back.
beefcake
10-22-2018, 11:45 PM
Thanks when i go into settings ip address , subnet mask , gateway , dns 1 and dns2 are all blank thxs.
Dodgem
10-22-2018, 11:48 PM
Thanks when i go into settings ip address , subnet mask , gateway , dns 1 and dns2 are all blank thxs.Do you have any other connections on the router and are they working?
beefcake
10-23-2018, 12:03 AM
Yes and there all working its very strange when i go into server setup its now says connected to server but not the internet thanks
Dodgem
10-23-2018, 12:44 AM
Yes and there all working its very strange when i go into server setup its now says connected to server but not the internet thanksAll i can say to that is that thats wierd
surfinisfun
10-23-2018, 12:45 AM
Do you know the reason for the power outage that started this problem?
beefcake
10-23-2018, 01:03 AM
Car hit a pole knocked all the south end of the city out of power so gonna let it sit for the nite and try tomorrow so thanks GUYS !!!!
countysat
10-23-2018, 03:26 AM
Try a hard reboot using the power button on the back of the box.
auggie
10-23-2018, 03:43 AM
Thanks when i go into settings ip address , subnet mask , gateway , dns 1 and dns2 are all blank thxs.
In ip settings is it set to static or DHCP, if static put to DHCP and let the router give it (assign) it a IP to use.
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.