T5 HD and SW21 switch

[janez]

Seems like T5HD don't work with SW21 switch.
I have no problem with NFusion HD and SW 21 switch for 2 sats
but the T5HD will only work on dish 1 port and not on sat connected to dish 2 port.
Is there any remedy for something like that?
Thanks

[chevy268]

you need to set 1 LNB power to ON ex: 110 LNB power off
119 LNB power ON

after this set your diseq switch 21 to 2 and scan each one

[haha11]

you need to set 1 LNB power to ON ex: 110 LNB power off
119 LNB power ON

after this set your diseq switch 21 to 2 and scan each one
How can you get signal if you set LNB power to off?

[Arlo]

You're right. A 22kHz switch doesn't seem to play nice.
I had an 8 port diseqc 1.1 switch laying around.
I have a triple lnb for 110,118, 119 and 129 on separate dish cabled to the triple
I'm running c-band on another receiver.

I tried the discqc 1.1 switch in between the T5 and ku band cable...
C-band on the other port.
That works! Set diseqc 1.1 in dish setup and all seems to be OK.
Cheap enough...but the 22kHz switch didn't work so well.

Good Luck!

AHHH!
Legacy Switch is the 22kHz switch.
SW21 Dish 1.
Then select the satellite inputs with LNB 22kHz on/off
That works.

[janez]

problem solved, changed the sw21 to ecoda 22khz, input Sat 119 to 1, the other sat to 2
stb 22 khz for 1 to ON, the other to off.
Works good
Thank you all for your help