Scrambled

[jctin]

Hi guys.

Start happening a week ago that channels will be scrambled. I changed the SW 21, hard wired 82 and 91 separately without the sw21, still scrambled. When i rescan, will get the blue signal strength and works perfectly again. Could it be that i have to replace the LNBm but then again, when i delete all channels and rescan, all is well. Or is it my internet connection? Thanks.

[auggie]

Hi guys.

Start happening a week ago that channels will be scrambled. I changed the SW 21, hard wired 82 and 91 separately without the sw21, still scrambled. When i rescan, will get the blue signal strength and works perfectly again. Could it be that i have to replace the LNBm but then again, when i delete all channels and rescan, all is well. Or is it my internet connection? Thanks.

Are you getting any Messages on TV screen like NO SIGNAL, etc.

[jctin]

Nope. Scrambled channel. But at times it will come on after some minutes

[nobodyspecial]

Unless you are getting no signal issues you should stop playing with your hardware and start looking at your network

[auggie]

one other thing it Might be is Heat issues (HD Module, PS board, etc.) if you haven't added extra Cooling Measures (Fans)
to cool things down, then the components inside are most likely Getting to HOT, which can cause problems

[pgjeepster]

sometime the power supply can create this issue as well, mine did and replaced power supply and fixed it up right away.

[Mavrick]

one other thing it Might be is Heat issues (HD Module, PS board, etc.) if you haven't added extra Cooling Measures (Fans)
to cool things down, then the components inside are most likely Getting to HOT, which can cause problems

If heat is the problem.......grab a 12v PC fan and solder a USB end onto it (many videos on Youtube on how to do this) then place the fan ontop of the receiver with the air being sucked out of the unit (not blowing into it), this will cool the unit down considerably.

[Mavrick]

sometime the power supply can create this issue as well, mine did and replaced power supply and fixed it up right away.

Open up the box and check all the capacitors for any bulging or leaking, a failing capacitor will cause the unit to do all kinds of goofy stuff.

[Newfygarge]

Did you take out the dl100/200 module to see if you get the sd channels. If so it's the module. Experienced the same thing this week. It was the module.

[sat9182]

sounds to me like your antenna settings or channel list gets corrupt if a re scan fixes it for while

I would factory reset the box
put in server settings
then antenna settings again and re scan

that should help all be fresh and not a over write
then see if it stays working