Trying to bridge lan and wireless connections on laptop

[The Wufman]

have been trying to get the lan port and and wireless to bridge so that I could use the lan port for an ethernet cable to feed internet to a dongle...have tried with the instructions here but so far a no go:http://www.satfix.net/showthread.php?t=18180

any ideas or suggestions

[boxingfan]

are you using crossover?

[dishuser]

are you going into properties/advanced of card and checking box for sharing?

[The Wufman]

the internal card stopped working awhile back so now I use a netgear wireless adapter connected to it for internet access..was trying to bridge that with the lan port so could use that to feed the internet to my CW700 dingle via ethernet cable

[The Wufman]

are you using crossover?

ok got the connections bridged but i think I may need a crossover cable as you stated..not working thru ethernet cat5 cable will get one tomorrow and retry and post back with results

[freddydog1]

ok got the connections bridged but i think I may need a crossover cable as you stated..not working thru ethernet cat5 cable will get one tomorrow and retry and post back with results

with a crossover cable you can follow a dial up guide ,,there is one in the nf phoenix section

[smith420]

share your lan with a wireless router then you can use a regular ethernet cable i am sharing my dial up with a router and now i got a wireless over a dialup network if you got 2 lan cards installed you could run the internet in to your computer through 1 lan and share that with the other lan