difunto252
10-24-2009, 01:03 PM
c/p
1. Load bin ( over current file if not virgin reciever)
2. Plug dongle
3. U will see prompt that dongle connecting (can take up to 30 seconds)
4. Click menu-installation-ipconfig
5. Setting type DHCP
6. USE DNS YES
7. Domain name svftaiks.com
8. Server port 1920
9. PUT IN YOUR SERIAL NUMBER BE CAREFUL THE LETTERS ARE VERY SMALL
Entering serial number for iHub
The serial number for the iHub as well as many electronic devices is in hexidecimal. Hexidecimal (commonly referred to simply as "Hex") only has 16 characters. They are the digits 0 through 9 and the letters A through F. If you look at the serial number for your iHub you will notice the letters are small lower case letters and may be hard to read.
For instance the letter "e" may look like a letter "o" with a slash through the middle but trust me it is an "e". When you go to the setup screen for entering the serial number look at the bottom of your screen and you will see a key for which remote buttons to use for the letters. Now just simply enter them and save and you are done
Use the PVR control buttons
there is a guide at bottom of serial # page that tells you
rewind button=A
play button=B
fast forward button=C
stop button=D
arrow right button=E
pause button=F
10. Go to apply and click OK (don’t exit or it wont save you must click apply)
end c/p
1. Load bin ( over current file if not virgin reciever)
2. Plug dongle
3. U will see prompt that dongle connecting (can take up to 30 seconds)
4. Click menu-installation-ipconfig
5. Setting type DHCP
6. USE DNS YES
7. Domain name svftaiks.com
8. Server port 1920
9. PUT IN YOUR SERIAL NUMBER BE CAREFUL THE LETTERS ARE VERY SMALL
Entering serial number for iHub
The serial number for the iHub as well as many electronic devices is in hexidecimal. Hexidecimal (commonly referred to simply as "Hex") only has 16 characters. They are the digits 0 through 9 and the letters A through F. If you look at the serial number for your iHub you will notice the letters are small lower case letters and may be hard to read.
For instance the letter "e" may look like a letter "o" with a slash through the middle but trust me it is an "e". When you go to the setup screen for entering the serial number look at the bottom of your screen and you will see a key for which remote buttons to use for the letters. Now just simply enter them and save and you are done
Use the PVR control buttons
there is a guide at bottom of serial # page that tells you
rewind button=A
play button=B
fast forward button=C
stop button=D
arrow right button=E
pause button=F
10. Go to apply and click OK (don’t exit or it wont save you must click apply)
end c/p