got switches need to play

[moneybags]

ok i got some switches to play with i would like to try and get 129 119 110 91 82 with them but not to sure how been looking at alot of pics but not to sure the switches are

emp 22khz
mulitswitch 5/4
multiswitch 3/4 any help would be great thank you

moneybags
10912

[Terryl]

The 22 KHz switch is just an A/B switch, 22 KHz on = port A, 22 KHz off = port B, or the other way around.

The top 3x4 is an old legacy LNB switch with a TV antenna input, LNB +13v and LNB + 18v outputs to 1 LNB, then the terrestrial input for the TV antenna, this switch does not use diseqc commands but the +13/+18 volt polarity switch from the receiver.

The 5x4 is for a standard Dish or DTV type LNB plus a TV antenna input, this switch uses diseqc commands.

They both require external DC power and will run 4 receivers.

More info can be found here.


http://www.emp-centauri.cz/products.php?page=products

[WillDekkard]

The 22 KHz switch is just an A/B switch, 22 KHz on = port A, 22 KHz off = port B, or the other way around.

The top 3x4 is an old legacy LNB switch with a TV antenna input, LNB +13v and LNB + 18v outputs to 1 LNB, then the terrestrial input for the TV antenna, this switch does not use diseqc commands but the +13/+18 volt polarity switch from the receiver.

The 5x4 is for a standard Dish or DTV type LNB plus a TV antenna input, this switch uses diseqc commands.

They both require external DC power and will run 4 receivers.

More info can be found here.


http://www.emp-centauri.cz/products.php?page=products

The 5x4 multiswitches that I have seen use 22KHz switching. 2 feeds from a Dual LNB to LNB-A(0 KHz), 2 feeds from a Dual LNB to LNB-B(22KHz), and 1 feed from an antenna or cable then outputs to 4 receivers. No DiSEqC commands in this switch.

For your 5 LNB setup you will need a 4x1 DiSEqC switch and the 22KHz switch that you have.
http://www.satfix.net/attachment.php?attachmentid=10913&d=1310705025