Zinwell wb68 switch

[eshan]

hi every one
i just connect 2 zinwell wb68 switch as shown in pic just need help to enter correct lnb port in my sv. i dont have any idea what port # should i enter. my port on 4in1 DiSEqC was Port1 for Sat110, port2 for sat118.7/119,and port4 for Sat91w should it will same as with these switch or ? any help will be great thanks

[Gold]

I moved your thread to the proper location...You should receive an answer here

[mechanicman]

i think you have to not only put the correct port but also use 22khz on and off for some of the sats.. take 110.. does it go into the 22khz section of the 6X8? then what port does it go into the diseqc? ok so put the port number and 22 khz on for sat 110 in your settings and continue on.

[WillDekkard]

If you are using SW21 switches with those wb68s then DiSEqC port settings are not used. You have to set the 22KHz to either ON or OFF and set the Legacy switch settings to SW21 LNB-A or LNB-B, accordingly.

[eshan]

If you are using SW21 switches with those wb68s then DiSEqC port settings are not used. You have to set the 22KHz to either ON or OFF and set the Legacy switch settings to SW21 LNB-A or LNB-B, accordingly.

i dont have any idea if i am using sw21 switch or not. just used sb68 switch with DiSEqC as shown in pics

[sump]

this sett up is not the best for what your trying to do ....


this may help ....



http://www.hometech.com/video/gc-wb68big.jpg

[satchick]

That's the exact same switch that he's using........ If you're suggesting that he use the flex ports, they don't work with any FTA receiver that I know of. Even in legacy DirecTV installs they're only used for a limited number of applications.

The diagram posted by the OP is correct, the switch functions like a 4x8 switch.

[eshan]

thanks every one i found out what are my ports every thing working fine got signal on all sats!

port 2 for sat119/118 with 22khz ON because its connected to 18v,13v to 22khz in zinwell then output from zinwell to port 2 in 4in1 DiSEqC switch then receiver

Port 2 4in1 DiSEqC switch for Sat 110 with 22khz Off because its connected to 18v,13v not to 22khz in zinwell then output from zinwell to port 2 in 4in1 DiSEqC switch then to receiver

Port 4 for Sat 91w with 22khz ON because its connected to 18v,13v to 22khz in zinwell then output from zinwell to port 4 in 4in1 DiSEqC switch then to receiver.
its my lnb setting in SV. so can any one tell how can enter these setting in Dreambox dm500s ? thanks