SW 38 How to add antena or cable to it on FTA

[a&b]

I need help i got switch 38 i can add 8 receivers on one dish but there is a port on the switch for antena or cable input need help how can i hook it up on fta Thanks

[WillDekkard]

You are speaking of a 3x8 multiswitch. 2input ports are for 1 LNB marked 13v & 18v. The center input port is for antenna or cable. You will need a diplexer switch at the other end of the cable before you input it into the FTA receiver. 1 port from the diplexer(as marked) goes to your receiver and the other output port(as marked) goes to the RF input on your TV.
http://www.satfix.net/attachment.php?attachmentid=11419&d=1316268605

[a&b]

Not this one about sw 38 here is link for picture and description thanks


http://item.mobileweb.ebay.com/viewitem?itemId=350274917008

[lme]

Not this one about sw 38

you will need this diplexer to split the signal.
see attached diagram.

[a&b]

Where it will go back to receiver

[slugworth]

Where it will go back to receiver

same thing as the picture,except it has 8 outputs instead of 4

[a&b]

Thanks for ur help so when I want to watch cable or air atn I have to switch off the receiver

[WillDekkard]

Please read my post - #2, below is a diagram so you understand the concept of adding OTA or cable feed to your system:
http://www.satfix.net/attachment.php?attachmentid=11422&d=1316315805