mulitiple signal

[amcor710]

could i pass two different provider signals thru one cable..want to run bev and dish signals also want to split the signal what switch should i use if any.two rooms using different receivers.

[WillDekkard]

Need more info on your setup. What type of LNBs do you have? Are there provider STBs in the mix or just FTA receivers? How many receivers? What type and how of switches do you have in your arsenal? Need more info in order to give you a good response.

[amcor710]

Need more info on your setup. What type of LNBs do you have? Are there provider STBs in the mix or just FTA receivers? How many receivers? What type and how of switches do you have in your arsenal? Need more info in order to give you a good response.

>> i have the regular lnb's(11250) trying to see if both bev and d/n signal can be passed thru one cable.two different receivers. bell receiver and ilink. kinda confusing, but here is what i'am trying to do...bev and d/n on seperate cable once inside the house there is only one cable to share going upstairs in one room bev rec,another room ilink rec.is there a switch that can be used to operate both rec at the same time

[WillDekkard]

>> i have the regular lnb's(11250) trying to see if both bev and d/n signal can be passed thru one cable.two different receivers. bell receiver and ilink. kinda confusing, but here is what i'am trying to do...bev and d/n on seperate cable once inside the house there is only one cable to share going upstairs in one room bev rec,another room ilink rec.is there a switch that can be used to operate both rec at the same time

I could not find a pic that showed only 1 FTA receiver and 1 Bell receiver, however the pic below will give you an idea how it would work:
http://www.satfix.net/attachment.php?attachmentid=11512&d=1317101698
Combine your 91 & 82 LNBs with a SW21 switch which would in turn feed the Bell Receiver. Join 91, 82, 119, & 110 LNBs with a 4x1 DiSEqC switch to feed the FTA receiver.

[amcor710]

thank's for your reply willdekkard...this is what i have hope you understand,i have 2 24inch dish one with bev the other with d/n,4 seperate cables going into the house but only have one cable going upstairs,once upstairs the cable split to 2 bedrooms,one room with bev receiver and the other with i-link,could i get a switch to work with both receivers at the same time.

[WillDekkard]

thank's for your reply willdekkard...this is what i have hope you understand,i have 2 24inch dish one with bev the other with d/n,4 seperate cables going into the house but only have one cable going upstairs,once upstairs the cable split to 2 bedrooms,one room with bev receiver and the other with i-link,could i get a switch to work with both receivers at the same time.

Sorry, you need 1 cable for each receiver. You can not use 1 cable for 2 receivers. In your setup you have a Bell receiver and a FTA receiver. The Bell receiver would not know what to do with 119 & 110 sats, as well will not recognize a DiSEqC switch. I can not think of a way of delivering a provider signal and a FTA signal(different sats) on 1 cable. If you were doing Bell only then that is a different matter and you could do both on 1 cable, however you would have limitations - not the best. I'm afraid that you will need to feed each receiver with it's own cable.