110 scanning duplicate channels

[Sanjeevnuts]

On scanning 110 I end up duplicating many 119 channels again
So side by side 2 channels with same number will show, one displaying 119, one displaying 110.

Only the one showing 119 works, so I presume 110 is the (bad) duplicate. How do I clean duplicate channels from it?
I'm using an ilink converted Nano2

[anyonomus]

On scanning 110 I end up duplicating many 119 channels again
So side by side 2 channels with same number will show, one displaying 119, one displaying 110.

Only the one showing 119 works, so I presume 110 is the (bad) duplicate. How do I clean duplicate channels from it?
I'm using an ilink converted Nano2

Write down "ALL" your antenna/switch/LNB settings and do a factory default..
Reinsert "ALL" antenna/switch/antenna settings and do a rescan on 110 and 119./. "once"
Watch TV..;)

[Sanjeevnuts]

Actually, I had to recover my box recently and had to reflash the boot loader.
So, yes, I had to do a factory reset many times and all scans are fresh.
Still I'm getting duplicates. Is there a list of transponders for 110 that I can compare with my current list?

[BHill]

Actually, I had to recover my box recently and had to reflash the boot loader.
So, yes, I had to do a factory reset many times and all scans are fresh.
Still I'm getting duplicates. Is there a list of transponders for 110 that I can compare with my current list?


Have a look here.


http://www.lyngsat.com/america.html

[StanW]

Actually, I had to recover my box recently and had to reflash the boot loader.
So, yes, I had to do a factory reset many times and all scans are fresh.
Still I'm getting duplicates. Is there a list of transponders for 110 that I can compare with my current list?Sounds like you have a defective switch or are scanning both sats at the same time - scan them individually. Scanning with the switch removed should eliminate this problem also ( and will usually pull in more channels)