This is the Turbo board. Notice the rubber and also the 4 small holes in the corner of the board.
To install the board open up your Dreamlink and right behind where the satellite cable comes in the box is where the board goes.
http://i881.photobucket.com/albums/a...20/noboard.jpg
You will see a post that has 4 pins. Thats how the board stays tight in the box. Also you will see 2 white strips on the main board and also on the Turbo board
Line up the 4 holes you see on the Turbo board with the post that has the 4 pins on the main board.
This pic the blue arrow points to the 4 pins on the main board and also the pink arrow's shows the place where the 2 white strips are that locks the board to the main board.
http://i881.photobucket.com/albums/a...420/arrows.jpg
So line up the Turbo board with the 4 pins and press lightly till you hear the board snap in place. If you dont hear a slight snap just feel to see if those 4 pins are coming thru the holes on the turbo board.
Also when installing the module you must be very careful when lining up the connectors. The ones on the board are fragile and if you are not lined up and apply pressure you will break one of the connectors and this will cause no signal.
So be very careful when installing you need only very little pressure to engage so don't press to hard.
Now take the black rubber and place it ontop of the Turbo board on the biggest black strip you see on it.
When done it will look like this...
http://i881.photobucket.com/albums/a...20/boardin.jpg
Now dont slide the cover back on or the black rubber may get out of place. Its very inportant that you keep that black rubber clean and also that it stays on the biggest black strip.
If it comes off your box will get really hot as thats what the rubber is for.The heat from the Turbo board hits the rubber and comes out the top of the box.
Unit will run warm but not hot but if you want you can add a laptop cooler fan but me i dont as the unit is just warm like a SD box would be.
There you are done installing the board now.
http://ftabeta.com/images/smilies/biggrin.png