Nano lite has lots of channels...it thinks.

I have a strange problem. The channel list showed 2 and 3 of the same channel, lets say ch105, but shows it as on 119, and on 110, and on 118. I Did a default, then re-scanned 110/118/119. I get the channels I'm supposed to but in the guide and the channel list, I see duplicates after scanning. I scanned each satellite separately, and when I was done, it still looks like I have 2, and sometimes 3 of the same channel, of course only 1 of them works. Any idea how to solve this?

Thanks in advance.

Quote:

---

Originally Posted by Steve44

I have a strange problem. The channel list showed 2 and 3 of the same channel, lets say ch105, but shows it as on 119, and on 110, and on 118. I Did a default, then re-scanned 110/118/119. I get the channels I'm supposed to but in the guide and the channel list, I see duplicates after scanning. I scanned each satellite separately, and when I was done, it still looks like I have 2, and sometimes 3 of the same channel, of course only 1 of them works. Any idea how to solve this?

Thanks in advance.

---

Does the correct sat appear in settings before you scan?

...Or you scanned it multiple times without first deleting channels or doing factory reset.........

Quote:

---

Originally Posted by torpainter

Does the correct sat appear in settings before you scan?

---

Yes it does. I always make sure of a lock with the proper name(otherwise there's no point in scanning)

Quote:

---

Originally Posted by Condor

...Or you scanned it multiple times without first deleting channels or doing factory reset.........

---

Read my post again. When I say a default, I mean that I did a factory reset, a fresh start if you will. Like I made very clear in my post, I scanned each satellite separately, but only once each.

Thanks for your help so far.

reload software file and factory default then try again Do a regular scan

Same channel name but on a different Satellite will come up every time!

Sounds like a switch going fubar.

Quote:

---

Originally Posted by JCO

Sounds like a switch going fubar.

---

Changed the switch to an sw-21 on Saturday, DiSEqC was shot.

Looks like I'm going to have to manually delete the non-working ones, or just put up with it.
Again, thanks for offering your advice guys!

If you delete all channels and do a fresh scan you should not have duplicates..

Im having the same problem. When I scan both sats 110 119. Even after doing a factory reset and deleting all channels, I still get doubles. Everytime I rescan and it produces channels for both sats.. for ex. 121 for 110 and 121 119.. I cant figure it out. I did also notice that the channels are sticking. for ex. when i put it on channel 830 ill have to go up or down a channel and then back down to 830? Any suggestions would be great.. Im not sure if these problems are related.. Thanks

did you change out the switch so you can rescan without dupes?