Multi satellite setup causing rebooting and wiping channels

Has anyone come across this? I am running Dish 119 port 1 diseqc, 110 port 2 diseqc, 129 port 3 diseqc, and Bev 91 port 4 diseqc through SW44, 82 port 4 diseqc through SW44. The receiver reboots constantly and then it will wipe all the channels. I tried to delete a pile of channels and any duplicates and it didn't work. I replaced the 8psk module and replaced the EMP Centauri diseqc with another one. Any ideas? Do I need an inline amp of some sort? Or is there another way to hook up my setup that will work better?

Have you tried factory defaulting the unit and starting from scratch again?

Quote:

---

Originally Posted by Anubis

Have you tried factory defaulting the unit and starting from scratch again?

---

I factory defaulted then loaded the cleaner via serial then factory file then newest file. It's something to do with the sw44 conflicting with the diqesc I think. If I don't hook up the sw44 it seems to work fine. I posted in the lnb section which I probably should have before. I explained it better there. But maybe you have some ideas?

Why the sw44? Is there subbed receivers also using the sw44? Also do you have a power inserter on port 1 of the sw44.
I've seen plenty of setups with the satellites you want. Usually the have bell 91 and 82 going to a sw21, which is then connected to port 4 of the diseqc.

Quote:

---

Originally Posted by fn59

Why the sw44? Is there subbed receivers also using the sw44? Also do you have a power inserter on port 1 of the sw44.
I've seen plenty of setups with the satellites you want. Usually the have bell 91 and 82 going to a sw21, which is then connected to port 4 of the diseqc.

---

Yes one sd Bell and one dual tuner Bell. I needed 4 outputs so that's why I installed the SW44.

Have you tried hooking up directly to the sw44 to see if you can scan both 91/82 ?