CNX Nano 2

In the beginning it work fine after I delete Satellite Channels it gave me ---- on stb .
I did a hard boot power off @ a back stb and unplug for awhile but it still no change.

Reload the 129 npn file it still do no change and factory files 805, to 810 it nothing happen but it gave me ERR5 on stb screen, than I converted Ilink to Nano2 original it show C 113 with red, and green dot lite.

Everyone had any experience like these give me a hand I'll appreciated a lot
plus I been read a lot posted but it still do no good for me

have a look at the sticky "Recovery File" its in the Nano2 files section.

c113 means it's stuck in boot.

I did look and work on whatever the file that said
if I miss something just put in order maybe my stb will wake up again.

I never had any bad time like this problem b4.

Found this while sniffing around on the net...maybe it will help and solve your issue:

C/P...kudos to the author..
-------------------------------------------------------------------------------------------------------------
Problem solve. error (C113)

Problem solve with the (C113) error in the front sreen of the cnx nano2 after rebooting from the back switch.
Thanks to Whacked_out for the help

How to get the (C108) Back after rebooting.

If you have a converted nano2 to ilink.

ilink back to NANO2
Prerequisites:
you must have the ilink 2.84 bin installed

1. Reset to factory defaults.
2. Upgrade receiver using the following file through USB stick: ILINK_TO_NANO2.ups. Use "S/W Upgrade" option on upgrade screen.
3. Reset to factory defaults.
4. Upgrade receiver using the following file through USB stick: NPN_1.29.NPN . Use "S/W Upgrade" option on upgrade screen.
5. Reset to factory defaults. You are back to NANO2 NPN 1.29 .

I loaded this bin with a USB
.
1- load bin NPN_809 factory.NPN
2- factory default (very important)
3- load bin NPN_8.10_ factory. NPN
4- factory default ( very important)
5- load bin NPN_1.29.NPN.

Now convert back to nano2 to ilink
NANO2 to ilink

Prerequisites:
- You must have NPN1.29 FW installed.

Process flow:

[NOTE: All factory resets are very important, the first time I tried doing this it didn't work and it was due to this step so do it!]
1. Reset to factory defaults.
2. Upgrade receiver using the following file through USB stick: NANO2_TO_ILINK.NPN . Use "S/W Upgrade" option on upgrade screen.
3. Reset to factory defaults.
4. Upgrade receiver using the following file through USB stick: IR2x0_2.84.ups . Use "S/W Upgrade" option on upgrade screen.
5. Reset to factory defaults. You now have 2.84 ilink BIN installed. It is good to go.

This is how i fix the (C113) error and got it back to the (C108).

Thanks and enjoy.
--------------------------------------------------------------------------------------------------------------
End C/P

I been working with these Nano2 all kind instruction but still can't solved or get my STB off from C 113.
What ever I load or flash, at the end hard boot from the back it came back C 113. Is it really a heart bit
STB put on me and can't done couple days already.

Don't know if it will help but check the thread below.

http://www.satfix.net/showthread.php...-not-work-HELP