Need Help X-FTA Gargoyle by Poroto40
I have a Viewsat Ultra using an X-FTA running Gargoyle Firmware by Poroto40.
The issue I have is running a server for Dish and Bev at the same time. In my case Bev is working fine while Dish is freezing.
If I add one server at a time then all is well, as stated above when I add both dish freezes and becomes unstable bev works fine.
here are my settings
# Up to 8 CaID's can be remapped.
#1841=1815
#1802=1816
1802:1816|1803:1816|
# Serial port receiver is connected to.
serial_port=/dev/tts/0
# Set baud to 19200 for most Viewsat, XFactor and CNX receivers that used
# a dongle.
# Set baud to 115200 for most other receivers and Viewsats running SSSP
# firmware.
serial_speed=19200
# Control word retrieval timeout in seconds.
server_timeout=8
# Number of attempts before connecting to a new server. Setting to '0' will
# make the client try the next server after first failure.
server_retries=0
# Receiver protocol
# 1 - Viewsat/X-Factor
# 2 - CNX
# 3 - SSSP Viewsat/SSSP Pansat/Coolsat
# 4 - Captiveworks
receiver_protocol=1
# If set to 1, CaID reported by the receiver will be ignored and ECM will be
# sent to server even if there is a CaID mismatch. If you are using a single
# provider you should set this to 1.
ignore_caid=0
Please give some insight on the what I should change or the optimal settings the have worked for you while running a bev and dish server at the same time ?
thank you.
