I'm not sure this is even an issue with this receiver only but this one transponder will not scan. All others lock fine. Settings are correct. Another person I spoke to has same issue. Any thoughts?
Printable View
I'm not sure this is even an issue with this receiver only but this one transponder will not scan. All others lock fine. Settings are correct. Another person I spoke to has same issue. Any thoughts?
You don't have a WIFI router close by to the receiver do you?
It is possible for something close to the LO or IF frequency to affect a transponder.
LO = 11250 MHz
IF of this transponder = 1280 MHz
1280 MHz is used for some drones with video downlink.
Interesting. There is a large wifi access point but not near by. I'll have it disconnected then test again. I'll report back. Thank you
I had the wifi disconnected but no change. I appreciate the suggestion though. Here are some more facts to think about.Quote:
Originally Posted by Terryl
The same problem is happening at two separate locations across 5 different receivers so this is not really a T6 issue, sorry for posting here. Maybe there is a better area to move this post?
Each location has multiple lines, all of which work perfectly except for this one TP. If you test the same line with an actual Bell receiver, Tp22 (12530) on 82w works fine which rules out alignment.
One thing that both locations have in common is they both are connected directly to a TwinDP LNB. One with a DP44 switch and one directly to the LNB. Nonetheless, the result is the same. 12530 will not lock on at all.
Any other thoughts or ideas are very much welcome.
Thank you!
are you able to change the polarity
like if it comes up V try to change to H
Just a thought
Changing it to H allows it to scan but it scans the wrong TP (not sure which one) and the wrong channels scan in and don't work.
Did you ever end up solving this?
Im having the same issue
The FEC is 3/4A on that TP. I know on the T5, there is no way to change the FEC to 3/4A. On other receivers, you can.Quote:
Originally Posted by Goldberg
^ I also have a jynbox.
Would it work on that. Cant see where to edit the FEC
I am not familiar with jynxbox, but that fix works with Sonicview 8000. Maybe some jynxbox expert will know.Quote:
Originally Posted by Goldberg
Have you successfully done this and been able to scan this tp using any receiver at all?Quote:
Originally Posted by johnnylarue
yes, with my sv8000 and my genpix/dvb.Quote:
Originally Posted by jon doe
Hmmm I've tested with an sv8000 with no success. I'm going to recheck the Fec and try again.
Thank you
Add 12530 as a new TP. Don't edit the one from the bin. it is FEC 3/4A, 21500, turbo-8psk, H or Auto works. It works perfect. Watching MLBHD right now.Quote:
Originally Posted by jon doe
^ Thanks.
Do you know of any TPs that need editing to work on Bev?
Wouldnt mind extra channels