my 3900 auto updated this morning and ever since has been stuck in boot, anyone know why or the fix for it? seeing other people are having issues with it too, thanks!
Printable View
my 3900 auto updated this morning and ever since has been stuck in boot, anyone know why or the fix for it? seeing other people are having issues with it too, thanks!
Have same problem.
Tried rebooting, no change
Unplugged to reboot, No Change
tried the same thing, a few times lol, no change here eitherQuote:
Originally Posted by Terry Mitchner
Try a factory reset, insert small pin in hole underneath device
i am stuck in boot mode also try factory data reset no luck
Sounds like a corrupt update is in the stream?Possible with this many units affected.Not their first one either.I will check & report on my 3900 when I get home.
Where is this tiny hole? . . . I removed the hard drive even to look there. . . . I see a little indent on the bottom near the rear centre in a rectangular panel but it does not seem to move or reset anything.
seen alot of people in the same boat, has to be a corrupt update like you said, tried writing buzztv about it but havn't heard back lolQuote:
Originally Posted by The Noof
Mine is down also, and I've looked everywhere can not find factory reset hole anywhere
After the update loaded, it started to install then at about 20% it shut itself down but did not reboot. I gave it 10 minutes then unplugged and rebooted it. It goes through the opening song and dance then sits for 15 seconds the reboots again going through the boot-up song and dance but at almost at the end it freezes.
a rom update came out for 7.1 3000 unitsQuote:
Originally Posted by The Noof
apparently it fubared the 3900
That's exactly what happened to mine. Tried to push indent on bottom still same. Sometimes boot music stuck on reverb too. Just received mine beginning of June. Thought auto update was turned off. Hope WWS gives me RMA authorization.
the update setting for rom isn't in live tv/menuQuote:
Originally Posted by kyzursozay
it's home/settings/update
That's the setting that I turned OFF after initial first turn on/setup when I received unit. But it must revert back to auto update ON whenever you remove power to unit. To turn on Wi-Fi I always had to use settings button on remote; hilight Wi-Fi; saved address; connect every time I unplugged/ turned unit ONQuote:
Originally Posted by dishuser