Does anyone runs USALS on Ku band using a HHmotor with a Dreambox?? Thanks
Printable View
Does anyone runs USALS on Ku band using a HHmotor with a Dreambox?? Thanks
Yes but problem is the setup is not ideal.
It's done using a switch or in my case I have dual tuner. I run ku on second tuner but first issue disec cmd before going to the ku folder so the box goes to second tuner so the dish moves if need be. I use 2 folders for each position, 1 c , 1 ku per satellite.
Do you mean a specific type of motor or any generic type ?Quote:
Originally Posted by cpr43
What's the problem you're having ?
Generic SG2100 HHmotor. I did all the settings. I picked Diseqc 1.2 , checked USALS, Add my lactitude/ longitude for all my Ku band sats. But when I change from 1 sat to another it doesn't do anything. The motor doesn't move at all.Quote:
Originally Posted by zayden
Running straight to the motor or do you have switches in the line ?
No switch StraightQuote:
Originally Posted by zayden
I'm running both C and Ku on a Dreambox with 22khz switch high side driving the Ku section, with a Diseqc and 4x2 multiswitch in line. Running without problems so it can be done.
You should only have to enter your lat/long one time ? How/why are you entering it for each sat ?
I will take a pic of my setting and post so you can help, ThanksQuote:
Originally Posted by zayden
Very good.
Try setting Diseqc 1.0 Command to "None" and maybe turn off "Use Power Management" if that's related to Power Threshold in ma (I don't have that one in my tuner settings) The motor needs current to drive the dish maybe that is set too low for it.
By the way which Dreambox is this and what image are you using ?
DM800HDse, Blackhole 4.7, elgato-cino-weather- skinQuote:
Originally Posted by zayden
I will try to turn off "Use Power Mgmt. Can not change Diseqc 1.0 to None, I am using a diseqc for 2 LNBs.Quote:
Originally Posted by zayden
Are you running your cable from the DM800 to the motor FIRST then to the switch ?Quote:
Originally Posted by cpr43
cable goes directly from the box to the HHmotor (To receiver Input). A coax goes from HH Motor "To LNB" to a diseqc 1.0 and 2 cables goes from port 1 and 2 to 2LNBs. Works perfect with all other regular boxesQuote:
Originally Posted by zayden
So the other setting didn't make a difference ?
HelloQuote:
Originally Posted by zayden
Sorry, I just tested this morning. It worked. Turning off the "Use Power Management" did the trick. Thank you so much!!!!����
Excellent, glad it's working.Quote:
Originally Posted by cpr43