Hi last nite around 10 pm i lost all my signal on my t5 would it be the box or my lnb thanks
Printable View
Hi last nite around 10 pm i lost all my signal on my t5 would it be the box or my lnb thanks
nobody can say or tell exactly what is the issue until or unless you tell them what you have done to troubleshoot.
how was the weather? did wind move your dish? any construction around house damaged dish? any power outage issue? have you ran a line straight from your dish to you box?
more info is better to get you help :)
Thanks the weather is bad today but i should get a little signal i have 2 cables comming from the dual lnb so i switched wires and still no signal and the dish has never moved thxs.
have you tried to rescan or change TP's around to see any signals?Quote:
Originally Posted by beefcake
I would say wait for weather to clear before you make things worse lol :)
8psk....take out the hd module & try it without .You won't get 82 but you should get 91.
thxs i just got my sonicview out and not getting a signal on it either so it has to be the lnb but its dam cold out there gotta watch my BILLS play at 1 pm
Hook-up Directly (no switches etc.) one cable to 91 straight to T5 & see if you get signal, if no
signal, then I would say either your LNB or cable is Bad/Failing.
Thanks guys after the game going to try to get outside and change the lnb thanks very much
Are you running through a switch? it doesn't necessarily have to be LNB. Could be the switch try running a line bypassing the switch this will let you know if it's LNB for sure
Must be a ECHO on here, cause I posted the same in Post # 7 ?Quote:
Originally Posted by pgjeepster
After over a hour changeing the LNB there still is no signal the dish has never moved i'm so confused its so cold out there .
are you positive dish never moved?Quote:
Originally Posted by beefcake
Yes i'm sure i have a magic marker on all the positions on the dish when your 78 my dish is my life thanks
Do you have the Right Type of LNB ? Have you hooked up Direct (NO SWITCH) Single cable right to the T5 ?Quote:
Originally Posted by beefcake
Is it a legacy or DP/DPP LNB ? We need more info to help you better etc.
What about running a new coax from the receiver directly to the LNB?
Its a bell DPP lnb runs directly to receiver thanks guys
You can eliminate the LNB by moving the "new" coax from the 91 to the 82 sat. There would be no way or super slim that both would go at the same time. If both then I would think the dish moved.Quote:
Originally Posted by beefcake
OK, that LNB has a built-in switch, you have to account for that in receiver dish settings LNB Type OCS-DP I believeQuote:
Originally Posted by beefcake
you can't move the coax to get a different birdQuote:
Originally Posted by maird57
it has a built in switch
correctQuote:
Originally Posted by auggie
and then pick correct port
it would be 91 and then 82
I'm a bit confused. I have a dual LNB on my dish for Bev. If I eliminate the sw21 switch I can connect the coax from the receiver directly to either LNB weather it's 91 or 82.Quote:
Originally Posted by dishuser
Ok now I understand that particular LNB has a built in switch.
You most likely have legacy LNB's, the DPP lnb with built-in switch band-stacks both signals down one cableQuote:
Originally Posted by maird57
and you separate them with the Receiver on the different ports, Like DU said
Correct about legacy LNB's, that's why I corrected myself...lolQuote:
Originally Posted by auggie
legacy setup is the way I have it as well, it is easier to do for me anyways, FTA boxes are used to 13v & 18v switching
and most don't have the power to support all the Newer stuff/equipment etc. to make them run right.
Thanks for all your replies they were great as usual i got a guy in last nite and changed a few wires and ends and got it running great but a hour ago i lost my signal again are we up and running good on 91/82 thanks
[QUOTE=beefcake;1362176]Thanks for all your replies they were great as usual i got a guy in last nite and changed a few wires and ends and got it running great but a hour ago i lost my signal again are we up and running good on 91/82 thanks[/QUOT
Are you getting any messages on TV Like no signal or bad signal etc. ? or did you lose the Signal Totally.
Its bad or no signaL THXS
have you changed out the power adapter that came with the T5 ? You need one that has more power like 12v 3.5-5amp
for the T5 to run right, and the DPP LNB's are power Hungry
Thanks i replaced it a couple years ago do you think its bad if it powers the reciever up thxs
what are the Specs on it, if it is under 3amps output it doesn't have enough power for your setup
Do you have a spare one you can try, that way you will know if it's the Power adapter or not.
Also how long are your cable runs ? longer cable runs Draw more power, Most of the issues with the FTA Receivers
these days, with all this power hungry Equipment are power issues, The receiver can't supply enough power to
all the stuff you are using.
You should also have COOLING MEASURES (Fans) in-place, that is a "MUST" To keep things cool inside the box
and for the Cheap components (caps, HD Module, etc.) that are installed so they don't "Over-Heat"
AUGGIE that was it went to the source and got a new adapter and i got my signal back THANKS BUDDY .