Printable View
Well the other day the damn wife wiggled a bunch of cords. Jynx froze. I shut off now i only got red and blue light. Normal loader dont work. I got the other loader too. Tried to jump the 2 pins. Dint work. I think i need a smaller wire. Seen many post on this. Can any one help me if they know of the proper way of doing this. Thanks
When i do this i am getting done initiate stb sdram is failed. What does this mean? Thanks
I got the same problem, and I saw that someone on ebay sell the U7 IC, I ordered one that the guy says "will fix it" and it didn't so now he says if I send my unit he'll repair it.......NOPE ain't doin it, when you or anyone find a fix please let me know. obviously the unit is bottom feeder
I'm still looking to bring this baby back to life
is there anyone out there that can provide info to bring this piece of garbage back to life.....I'd still like to play with it
I had one do it and ordered the chip from ebay, soldered it on and I was back in action.
Last I checked they chip was not on ebay but it worth a search.
I saw one with the red and blue lights years ago, and have been trying to remember since I read this yesterday but it was a long time ago...Quote:
Originally Posted by joanz
just like Dave, the guy blamed his wife for causing it by moving the tv cabinet. I went over there and took the jb200 out and put it back in and it booted up normally but there was no signal on 119. I swapped out the jb200 with a new one and still didn't have a signal for 119. I tried a factory reset but was never able to correct that problem. He had a 2nd receiver in his bedroom so he switched them out and got thru life with no 119 in his room.
hello all
I have a jyazbox v16,(same as jynx but cheaper). When my jyaz died with just a red light showing,I found that on the power board the
EC3 capapciitor was a little puffy and had blown out the bottom. 4 screws and ribbon cable off the main, power plug off, flip board get 1000umf 24v cap $1.50 from tv repair shop, replace your self easily for free or give to shop. back to normal. Check other caps while in there for bulged tops. The EC3 is printed on the board next to the tall cap.
If you have an eeprom programmer, i can provide you with a valid U7 eeprom file
Curious what software you use?Ponyprogram???I still have my epp/atmel programmers.Pretty dusty though.lolQuote:
Originally Posted by str3atwarrior