Results 1 to 2 of 2

Thread: PAL to NTSC after a factory default

  1. #1
    Join Date
    Oct 2012
    Posts
    18
    Satfix Buxs
    25
    Thanks
    0
    Thanked 11x in 5 Posts

    Default PAL to NTSC after a factory default

    Here are the directions for bringing the AzBox from PAL to NTSC. After a factory default and reboot the receiver defaults to PAL. To change the format to NTSC do the following steps using the remote:

    1) Reboot the receiver by the switch on the back of the unit. Wait until it powers up and the display is scrolling
    2) Hit the Down Arrow 6 Times
    3) Hit the OK button
    4) Hit the Right Arrow 1 Time
    5) Hit the Down Arrow 1 Time
    6) Hit the Right Arrow 1 Time. You have now changed the display setting from PAL to NTSC
    7) The receiver will ask you if you want to save your change and say YES

  2. #2
    Join Date
    Oct 2009
    Posts
    22,807
    Satfix Buxs
    2,206,751
    Thanks
    36,977
    Thanked 26,256x in 7,929 Posts
    Items GreeceCanada

    Default

    On my azbox ultra, which is being used exclusively for true fta, all you need to do is press the resolution button on the remote. Are those above instructions for other azbox receivers?







Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •