All users, remember to follow these steps when loading the bin:
REMEMBER TO DO THIS EVERY TIME YOU LOAD A BIN.

• Connect USB A-B cable to PC and DM100
• Open Xloader and Click on AUTOCOMM and press OK
• Click on Upload and upload BIN file
• After a few mins, it will complete uploading the file. When complete, click OK and then click on Disconnect and Unplug DM100 from PC.
• Connect the Receiver to plug outlet and to TV, switch on and press 0+0+0+0+EXIT+EXIT to switch from PAL>NTSC!
• Perform a factory reset (A MUST) – Menu > System Settings > Factory Reset, Press OK!
• Connect DM100 to a network port via ethernet cord. Go to Expert setup and type pin 0000. Make sure you get connectivity via dhcp. Go there once, select dhcp, exit and go there again (you’ll find the ip changed from 0.0.0.0 to a working ip; there’ll be a working DNS, etc. If not, check your internet connection and try again!)
• Scan the desired satellites after making sure you have a solid signal (If you have problems scanning with auto, manual scan with the desired tp’s).
• Go to expert setup and Press 0101
• You will see a hidden menu
• Go to Card Client Setup
• Go to NEWCAMD
• Under Host select, change from host ip to host name and type the fenfu.dynsite.net or fenfui.dynsite.net address under host name.
• Type port : (is sent with your access code)
• Type username and password (access code)
• For DES KEY type (is sent with your access code)
• Save and exit