Guide to fix BOOT LOOP
C/Pfrom WebWizard...................1. Start the loader and set the com port.
2) Select file to you want to load.
3) While holding in the front panel power button reboot box and hold power
button on box in for at least 5 seconds while rebooting.
4) boot should freeze in display.
5) Press start on loader and file should begin transfer. When countdown is less
than 4 digits numbers are prefixed by letter A will appear.
6) When the display hits zero it should change to -E5-.
7) WAIT !!!! The Display on loader should be at 90% at this point.
8) The receiver should then start counting down prefixed with a "P". I assume
that is for 'PROGRAMMING'.
9) When the receiver displays -End- wait a few seconds, look at loader program
which should now be complete, and then reboot box.
(by WebWizard)
I have tested this on 4 different receivers an feel that this method works quite well....