Correction it may show USBL on the display once the file loads...been a while since I forced loaded and one way shows USBL and the other shows good on the display.
Correction it may show USBL on the display once the file loads...been a while since I forced loaded and one way shows USBL and the other shows good on the display.
I hope it comes back with the factory file and viewable on the tv screen...and if so you can then reload the p2028 file you were using prior to and hopefully be back to where you need to be.
Success, I now have the main menu. Should I go straight to loading the 2028 rom file now?
Sorry, I guess we were typing at the same time. Will give it a try.
I would setup Sats and scan in first get it the way you want it first
Then do the 2028 rom last
You can give it a go...you can load that one the same way and hopefully you will see adapter connect once the receiver reboots...at least I hope so...you will be a pro with force loading time you are done.
OK, YOUR GETTING there, you will need to go into dish settings and set that up according to the hardware you have
(LNB'S, SWITCHES, ETC.) Once you get it up and running I suggest you save (write it down) as much info as you can
for the setup you have. Good Luck, if i can help i will try.
Auggie
Leave switches out for setup (hook direct) if you can, once your up then add them in later
Never , never, never use Channel Master to loads channels to any receiver.
You may brick very easy receiver.
Channel Master is a worst cr&p I ever come across, it is so buggy, that it is beyond any imagination.
It is not even good for its primary goal, converting, sorting channels.
It crash so often, that whatever you do, after each operation u have to save your work. Otherwise, you loose hours of work and have to start from the begining.
Good to know, thanks.
Ok then, also if you are using the disq switch that came with the sv360P
they are junk, suggest getting a better quality switch (EMP, CHIETA)