Results 1 to 3 of 3

Thread: IKS registration error

  1. #1
    Join Date
    Jan 2014
    Posts
    5
    Satfix Buxs
    29
    Thanks
    0
    Thanked 2x in 2 Posts

    Default IKS registration error

    I am try to recover and setup a CNX Nano 2 for a friend. I have an issues getting the IKS configured. The dongle at the back of the unit has no light or power source so I dont think any file is needed for this dongle. After reloading the factory file and bin I can configure the network setting. I not sure if this receiver still works as I have never used one.

    My action are as follows:
    1. Loaded factory file NPN 8.06 ldr (8.09 and 8.10 results in C108 on display) using RS232
    2. Loaded file NPN 1.29 NPN using usb
    3. Connect dongle and apply (DHCP) IP address
    4. Successfully scanned (119) channels
    5. Attempt IKS registration which fails after about 1 minute and reboots receiver.

    The system info after completing the steps above is: -
    SW: Mov 1.29 LDR 1.08
    HW Ver: 1.00
    USB 2.0 Driver 1.00
    Nano 2 (2)

    Thanks for all advise.

  2. #2
    Join Date
    Oct 2009
    Location
    SE of N...NE of S
    Posts
    3,401
    Satfix Buxs
    2,945
    Thanks
    6,690
    Thanked 4,077x in 1,531 Posts
    Items USACokeFriesTVDishBurgerBox of crappoison

    Default

    Going to have to convert it over to an ilink...procedure is in the link below...note the changes in the remote functions once converted...can make navigating the menus a bit ticklish lol :

    http://www.satfix.net/showthread.php...n-USB-friendly

  3. #3
    Join Date
    Jan 2014
    Posts
    5
    Satfix Buxs
    29
    Thanks
    0
    Thanked 2x in 2 Posts

    Default

    Thank. I will do as advised.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •