hello all;llllllllllllllll
hello all;llllllllllllllll
Last edited by freeatlast28; 05-14-2015 at 01:28 AM.
I'm pretty sure your receiver will not power up the lnb you will likely need one of 2 things # 1 a power inserter or # 2 a bell or dish ird.
Please do not PM Me with questions
Post them in the forums so others may learn and benefit from your experience.
Yup that is true ..sub will do it
you could also swap out for legacy lnb's and use a switch.
Please do not PM Me with questions
Post them in the forums so others may learn and benefit from your experience.
i have a viewsat max hd and the same lnb and mine works just fine. yes you use one cable to lnb.
lnb type will be ocs-dp or dishpro
diseq on and 91 assigned to port 1
diseq on and 82 assigned to port 2
---------------------------------------------------------
Thanks for everything and the years of fun and friendship!!
DPP lnb draws less than 500mA. More if another lnb is connect to the input.
been gone from xfta will vs 2000 still work
does G router 802.11G still work with new stb for dn ===brand stb do you like
You are asking these questions in the wrong place. Go to the general receiver section found here to start off ....http://www.satfix.to/forumdisplay.ph...er-Discussions
There are several posts asking the same question. Right now I would get a Dreamlink or Jynxbox clone.
As for the router I would upgrade it.
Last edited by Anubis; 12-31-2015 at 04:06 AM.