Results 1 to 2 of 2

Thread: Programing the Remote control

  1. #1
    Join Date
    Oct 2009
    Location
    SE of N...NE of S
    Posts
    3,401
    Satfix Buxs
    2,945
    Thanks
    6,690
    Thanked 4,077x in 1,531 Posts
    Items USACokeFriesTVDishBurgerBox of crappoison

    Default Programing the Remote control

    Programing the RCU

    Automatic Code Search:

    I. Usnig Automatic Code Search
    1) Turn on the component you want to control (TV, VCR or DVD).
    2) Press and hold the component key you want to program. Holding the component key until the LED on the
    remote control turns on, then release the key.
    3) Point the remote at the component, press and release the UP (▲) button, then wait three seconds or
    until the LED stops flashing.
    At this point the remote control is searching for the correct code to program. If, after three seconds, the
    component you want to control does not turn off, press and release UP (▲) button again to tell the
    remote to search the next set of codes.
    4) If the component you want to control does turn off; Press and release OK Button , then the LED blinks
    three times.

  2. #2
    Join Date
    Oct 2009
    Location
    SE of N...NE of S
    Posts
    3,401
    Satfix Buxs
    2,945
    Thanks
    6,690
    Thanked 4,077x in 1,531 Posts
    Items USACokeFriesTVDishBurgerBox of crappoison

    Default Programming the RCU Using Direct Entry Method

    II. Using Direct Entry Method
    1) Turn on the component you want to control (TV, VCR or DVD).
    2) Locate a Code List. Find your brand of the component you want to control.
    3) Press and hold the component key you want to program. Holding the component key until the LED on the
    remote control turns on, then release the key.
    4) Enter 3-digit code from the code list, then the LED blinks three times.
    5) If you get no response, repeat these steps using the next code listed for your brand until the component
    responds to the remote control command.

    **Note...maybe best to google to find the newest code for your component...found a three digit code for my LCD tv but it doesn't completely work all the options...such as the input source which I need when going from OTA to stb.**

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •