No need to delete all 110w TPs and stuff with the Dreamlink Boxes. Just go to each 110w TP and change the S/R and Transmission info and scan that TP and then onto next and etc...

So, with the Dreamlink HD receiver go into Manual Scan menu while on the 110w sat.
The first TP shown in there as TP Frequency [1] is 12.224 GHz
Look just below that and you'll see the Symbol Rate slot, change that to 21500 MS/s and Polarity should be V.
With the Transmission slot, change that to Turbo and notice if the single bars change. If you have a lock and signal now then hit the Red button and scan that one TP
After scan then in same menu (manual scan menu), scroll to TP [2] and do same thing, and so on.
Also ensure FEC is always in Auto.

If you get a message saying TP already exists then exit out till the S/R turns back to 20.000 MS/s and then scroll to end of TP list to find the same TP but with the 21.500 S/R already correct. Delete the 20.000 one and scan the 21.500 one.

Sat 119w will be different with the TP order on the Dreamlink receivers. The Team put a ConUS Beam TP as TP #1 in their bins for better user experience. But the actual TP number 1 is not what the DL shows when looking at the 119w sat. The one they have as number one is atually number 5 or 6 I think thru DN Uplinks.
That's not really a concern right now thou, as this is so far about the 110w sat , so far.

This was performed on the Dreamlink HD PVR original box, not the T5.. but most functions on these Dreamlinks will be similar if not the same.

(crazed)