well i actually need alot help lol. this is were i am right now! Dish motor i have it on diseqc 1.2 Well i had to move dish motor to get 110, Had to move it and then play with the tp till i found signal, I saved it and scanned it with blind scan and with network on, The signal is 64 only. So then i did the same thing to find 119 and the signal is 85, same ways again to get 129 and its close to 119 and its signal is 85, also same way for 91 and 82. But now its all mess. I change it to 307 on 110, It moves to bell, press last button ,back on remote it goes back to 110, What do i do? I try and do epg and it doesnt, bounces to 110, or 119 when i press blue epg button the screen says. Id like to no maybe i am save sats wrong in my settings. Also tps id like to no if i have to change them in the setting to 8psk or qpsk. sorry i ask lots question in this quick reply. I no there will be more questions down the road. Answer 1 step at time till we figure it out. thx all