I'm not sure this is even an issue with this receiver only but this one transponder will not scan. All others lock fine. Settings are correct. Another person I spoke to has same issue. Any thoughts?
I'm not sure this is even an issue with this receiver only but this one transponder will not scan. All others lock fine. Settings are correct. Another person I spoke to has same issue. Any thoughts?
You don't have a WIFI router close by to the receiver do you?
It is possible for something close to the LO or IF frequency to affect a transponder.
LO = 11250 MHz
IF of this transponder = 1280 MHz
1280 MHz is used for some drones with video downlink.
♫♫♫ I’m a lumberjack and I’m OK ♫♫♫ I drink all night and sleep all day. ♫♫♫
Coming soon to a crop circle near you.....
There is a 66 and third % chance that I'm on the right planet...
"I'm happier then a Jackalope in a balloon factory"
"First rule of testing satellites"
"If its working fine now, then don't mess with it"
"Second rule of testing satellites"
"If you did mess with it, and now it doesn't work, can you blame someone else?"
"Third rule of testing satellites"
"If you did mess with it, and it doesn't work now, and you can't blame someone else"
"Can you HIDE it"?
Interesting. There is a large wifi access point but not near by. I'll have it disconnected then test again. I'll report back. Thank you
I had the wifi disconnected but no change. I appreciate the suggestion though. Here are some more facts to think about.
The same problem is happening at two separate locations across 5 different receivers so this is not really a T6 issue, sorry for posting here. Maybe there is a better area to move this post?
Each location has multiple lines, all of which work perfectly except for this one TP. If you test the same line with an actual Bell receiver, Tp22 (12530) on 82w works fine which rules out alignment.
One thing that both locations have in common is they both are connected directly to a TwinDP LNB. One with a DP44 switch and one directly to the LNB. Nonetheless, the result is the same. 12530 will not lock on at all.
Any other thoughts or ideas are very much welcome.
Thank you!
are you able to change the polarity
like if it comes up V try to change to H
Just a thought
Changing it to H allows it to scan but it scans the wrong TP (not sure which one) and the wrong channels scan in and don't work.
Did you ever end up solving this?
Im having the same issue
^ I also have a jynbox.
Would it work on that. Cant see where to edit the FEC
Hmmm I've tested with an sv8000 with no success. I'm going to recheck the Fec and try again.
Thank you
^ Thanks.
Do you know of any TPs that need editing to work on Bev?
Wouldnt mind extra channels