A picture of your two dishes and the LNBs would also help.
If you have two dishes than you probably have a Dish Pro single or dual LNB on each dish - with one dish pointed to the 110 satellite and the other dish pointed to the 119 satellite.
I would bypass the switch first to make sure you are getting a signal from each dish.
Take the coaxial cable off of the DP34 that is going to Port 1 (To Dish) and join it to the cable going to your receiver with a coax barrel connector - this will give you a direct connection to your dish bypassing the switch.
Now go to your DreamLink receiver go to Installation and then under Dish Settings
under Satellite select 119.0W EchoStar 14
LNB Power: ON
LNB Type: OSC-DP
LNB Frequency: 11250
LNB 22KHz: Off
DiSEqC SW 1.0: 1
DiSEqC SW 1.1: Off
Legacy SW: Off
You should get a blue signal bar for S and Q at the bottom and at the top it should say EchoStar 14 119W
If you are not getting a signal - then you may have to repoint your dish.
If you are getting the 119 signal - then do the same thing for the other dish - 110
Take the coax off of Port 2 on your DP34 and connect it to the coax cable going to your receiver with a barrel connector - select Satellite 110.0W EchoStar 10/11 (leave all other settings same as you used for 119) and see if you are getting a signal for the 110 dish.
If you are getting both signals - then put the 119 dish coax into Port 1 on the DP34 and the 110 dish into Port 2.
Under your DreamLink sat settings use DiSEqC SW 1.0: 1 for 119 and use DiSEqC SW 1.0: 2 for the 110
Last edited by jedi; 02-01-2018 at 02:15 PM.
NipPEr Is a diSh liCkeR!
4e697050457220497320612062755474206c69436b655221